The brake wear indicator is a non-reusable sensor that is installed in the brake pad. If this sensor is activated then the entire sensor must be replaced. Parts are available on-line if you are not close to a MINI dealership. After the worn sensor is replaced, you turn the key to position II without starting the car and wait for the light to reset.
The sensor can be replaced without removing the caliper.
how to reset the brake service indicator on mini cooper s 2011
How do you turn the brake indicator off on mini cooper s 2008?
If you mean the Flat tire indicator button, it's next to the parking brake.
Hold down the tire indicator button for about 10 seconds while driving. That is located under the Hand Brake.
For Example: On a 2004 Mini Cooper S - After a brake service/repair has been properly completed (including replacement with a NEW wear sensor) The brake wear indicator light on the instrument panel can be re- set (turned off) by: 1)car in NEUTRAL and the parking brake OFF 2)WITHOUT STARTING THE ENGINE 2)Turn the key ignition to position 2 while holding down the brake petal. The light (if by magic) will turn off (after about 15-20 seconds). If it does not - continue to hold down the brake pedal until the light does go turn off. It may take a little longer.
When the Mini cooper 2003 airbag light is permanently on, then it needs to be reset.
you dont
usually next to the change oil indicator there will b a small hole use a paper clip or something similar to push in and reset
a snowflake
Dot 4
if no one knows go to google.
To reset a Mini Cooper key, get in the car and close all the doors. Put the key in the ignition, turn it to the first position then back again to off and remove the key. This must be accomplished within 5 seconds.