Replace the brake sensor then the message will go away. When you saw the message the sensor is already bad so it need to be replaced along with the brake pads. You don't need to replace front and rear sensors at the same time. Any of them has the pads wearing too much (usually in the rear because Mercedes cars drive by the rear), that where the sensor need to be replaced. There is no electronic reset for brake pad wear message.
how do you reset the low tire pressure warning light on a 2009 camry
ABS warning RSC service now warning message
anybody have any info on a 2009 ml320 how to reset service message?
see:- http://grumunkin.blogspot.com/2009/08/how-to-reset-service-indicator-on.html :-)
Turn the ignition on, engine off. Press the brake pedal down twice, then the gas pedal twice in ten seconds. Key off, then on and should be reset.
The owners manual from my 2010 Ford Edge Limited states that you must drive the vehicle for 2 minutes at over 20 mph before the warning light will reset.
The only way to reset the low tire pressure warning light is to remove or replace the low tire pressure sensor. When the sensor is not working properly the light will remain on.
Inflate the tires to proper pressure. Make sure you check the spare too. It is included in the tire low pressure warning system.
unhook battery, step on brake pedal, wait 30 mins.
turn key off and then on , leave it in run not start position, at the same time hold brake and gas pedal for 20 seconds it will reset the oil light ..
The ABS light is on because there is a problem with the ABS (Antilock Brake System). Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself after a short drive.
How to reset Navigation 2009 Acura TSX