Battery disconnect or a scan tool.
You may need to replace the power control module.
disconnect battery for 30 seconds
If you fix the reason the light came on in the first place the check engine light will reset itself after a few drive cycles.
Charging system failure:::,check alt.voltage regulator is inside engine controller
That is the check engine light, see related question below.
see link below, should look like the picture there.
That sounds like problem in the cluster. The high beam indicator is cross wired to the check engine light when it shouldn't be.
try replacing the thermostat
CAR WONT START Transmission may not shift. Check engine light could be on.
To reset the check engine light on a 2000 Dodge Intrepid, you can disconnect the negative battery terminal for about 15 minutes. This will erase the trouble codes and turn off the light. Alternatively, you can use an OBD-II scanner to clear the codes directly. However, if the underlying issue causing the light to turn on is not resolved, the light will likely reappear.
To reset the check engine light on a 1999 Dodge Intrepid, you can disconnect the battery by removing the negative terminal for about 15 minutes. This will clear the computer's memory and reset the light. Alternatively, you can use an OBD-II scanner to clear the trouble codes that triggered the light. However, if the underlying issue isn't resolved, the light may come back on.
There is no individual fuse. The ECM has 2 or 3 fuses, and it controls the check engine light.There is no individual fuse. The ECM has 2 or 3 fuses, and it controls the check engine light.