Emissions and Exhaust Systems
Check Engine Light
Dodge Intrepid

Why is check engine light coming on your Dodge Intrepid?

111213

Top Answer
User Avatar
Wiki User
2005-12-23 15:13:11
2005-12-23 15:13:11

You may need to replace the power control module.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Check Engine code of P0404 (EGR)

User Avatar

You will have to check in with Dodge.

User Avatar

No, it will not, design is much too different to make it feasable. For a 2000 intrepid you must use a 1998-2001 engine. Check out dodgeintrepid.net for a ton of info on these cars.

User Avatar

Check the trans for codes with a scanner and diagnose the code you get.

User Avatar

Charging system failure:::,check alt.voltage regulator is inside engine controller

User Avatar

Check the coolant level. Check the thermostat.

User Avatar

Valve clatter? Check oil level and pressure? Fuel mixture?

User Avatar

see link below, should look like the picture there.

User Avatar

If you fix the reason the light came on in the first place the check engine light will reset itself after a few drive cycles.

User Avatar

CAR WONT START Transmission may not shift. Check engine light could be on.

User Avatar

the crank sensor is on the passenger side of the car on the back of the engine. Check right up there by the transmission housing.

User Avatar

That sounds like problem in the cluster. The high beam indicator is cross wired to the check engine light when it shouldn't be.

User Avatar

Trouble code P0432 means:Main catalyst efficiency below threshold

User Avatar

Have the trans computer checked for codes, and ask a new question about the code you get.

User Avatar

Not legally and not with out the check engine light coming on and staying on.

User Avatar

You can go to your local auto store (auto zone, advanced auto parts) and they can read the code and reset it for you.

User Avatar

Trouble code P0131 means:O2 sensor circuit low voltage (Bank 1 Sensor 1)

User Avatar

There is no individual fuse. The ECM has 2 or 3 fuses, and it controls the check engine light.There is no individual fuse. The ECM has 2 or 3 fuses, and it controls the check engine light.

User Avatar

The check engine light stays on when the computer detects an emissions related failure.

User Avatar

Check the clutch plate or have it checked.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.