0
Just take off negative battery cable for a minute and reconnect, that will clear codes and reset. If you still have ecm components (sensors) problems, computer will pick up codes again.
Wiki User
∙ 12y ago
Anonymous
Hit it with a sledge hammer !
Add your answer:
Earn +20 pts
Can you take interior from a 1993 Chevy g20 and put in a 1986 Chevy g20?
yes you can.
The location of the fuel pump or reset switch on the fuel pump on a 1993 Chevy G20 conversion van?
Chevy did not use a reset switch on there trucks. The fuel pump is inside of the fuel tank.
What transmission is on a 1993 Chevy G20 van?
4L60e
What tranny is on a 1993 Chevy G20 van?
4l60-e
What is the fuel system on a 1993 Chevy G20 van?
It is fuel injected.
How do you get the anti-lock light in dash to come off on a 1993 Chevy conv. van g20?
you have to have a diagonstic reader to reset the light. Before you reset the light make sure there is nothing wrong with the abs or the sending unit on the abs
How do you remove front coil springs on 1993 G20 Chevy van?
ejaculate on them
Where is the computer on a 1996 Chevy G20 van?
under driver seat
Where is the fuel filter on 1993 Chevy G20 van?
The fuel filter on a 1993 G20 van should be located on the vans frame. It is an inline type and should be easy to change.
How do you reset or turn off the service engine light in a 1989 Chevy G20 Van A new oxygen sensor was installed?
Disconnect the battery for 5 minutes will reset the computer on most models. If this does not work then your vehicles computer has the ability to hard set a check engine code and requires a special tool to reset the code.
How much R134A gas does a Chevy 1993 G20 need?
it gets 34 miles to the gallon
What is the 4 speed automatic transmission that came in the 1993 Chevy G20 vans?
That would be a 4L80E Transmission.
