go to task manager/ processes /end task or enter cmd in open program and type in <kill/ond/15/bhonda>
To reset the computer disconnect the battery for several minutes then reconnect.If the check engine light is off after reconnect then your computer has been reset.
You do not have to reset the computer after this repair. If the Check Engine Light is on it is not because you made this repair. If you disconnected the battery the computer will reset itself.
The engine computer can be reset with a scan tool or by unhooking the battery.
To reset the service light on a Grand Scenic 54 the engine's computer should be reset. An easy way to reset the computer requires unplugging the battery for 5 seconds. The computer will then reset.
The engine computer on a 98 Holden Vectra is reset by disconnecting the battery for 30 seconds. This allows the computer to power cycle much like a home PC.
If you are looking for an inertia/reset switch, the answer is no. The engine computer controls the fuel system with relays.If you are looking for an inertia/reset switch, the answer is no. The engine computer controls the fuel system with relays.
try unhooking battery cables and then rehooking them up, most of the time that will reset the computer if not you may need a new computer for it, and they are not cheap!!!!
Need to reset computer...
NO
To reset the computer in a Ford van, disconnect the battery by removing the negative terminal for about 15 minutes. This will clear the computer's memory and reset the system. After reconnecting the battery, turn the ignition to the "on" position without starting the engine to allow the computer to reset fully. Finally, start the vehicle and let it idle for a few minutes to recalibrate the engine parameters.
You do not have to reset anything. but you should have the battery disconnected. and once you reconnect the battery it will reset your computer.
Unfortunatley you will have to get it reset by a garage with a diagnostic computer. Costs around £25 to £35