Want this question answered?
renault guy says providing there are no faults turn your ignition on without starting engine, have drivers door openand press lock button on keycard put keycard in reader and press start button for 5 seconds. pull large part of manual handbrake handle and push small button with red light without letting go of larger handle and you should hear the handbrake motor reset some time you will have to do I did this yesterday on a 04 plate and it worked fine
If you lift your boot and under the boot carpet is a compartment with a hazard warning on it. Lift the cover off and you will see a handle pull that hard and it will release the brakes on the back wheels.This will probably leave you with a warning on your dash saying Parking Brake Fault. To cure this and get your handbrake working again take the negative lead off your battery and put it on again the ECU resets itself and the warning goes off your dash and your handbrake is working again. You would then have to reset your emergency handle in the boot that is excatly were i am up to as my brakes locked over the weekend and i had to use the emergency handle to release them but i dont think it is to hard looking at the manual or take it to a competant garage and i'm sure they can do it quite cheap.
To reset the service light on a Grand Scenic 54 the engine's computer should be reset. An easy way to reset the computer requires unplugging the battery for 5 seconds. The computer will then reset.
how do you reset code for remote central locking on renault megane scenic v reg
There is a button by the handbrake hold it for a few seconds it turns it off
Tickel it and smile!
yes youcan
It will have to go to a garage with the correct equipment to have it reprogrammed, its not possible to do this at home.Hope this helps
A manual circuit breaker must be reset by hand, as opposed to an automatic circuit breaker, that may be able to reset itself once it cools down.
Trip to the stealers Only..............
The best way to reset it is to READ the manual.
A Caliper Reset Tool is a tool used to 'reset' the brake caliper piston on calipers with an integral handbrake system. The tool spins the piston while applying pressure to compress it enough to replace the old pads with newer thicker ones.