Use an OBD scan tool to reset or disconnect the battery
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
To reset the Check Engine Light you must go to the trunk of your car get a cro-bar and smash the dash board until the light doesn't come on no more...
The check engine light problem will have to be repaired in order to have someone with a scanner to reset it. If the repair is not made then the light will come back on immediately.
Disconnect the red terminal on battery and let it sit for 15-30 minutes, reconnect the battery and check engine light should be off because the computer has been reset.
Assuming you want to clear/reset the check engine light, if you have successfully made repairs to correct what was the cause of the check engine light to go on the light will clear itself after a few drive cycles.
Fix the problem and hook up a tech 2 to it and clear codes
This light has to be reset by the person doing the oil change. It is not automatic when the oil is changed.
With an automotive computer or they'll do it for free at any AutoZone or PepBoys, or any automotive store.
See How to Reset the Change Engine Oil Message on page 6-18 of your "Owner's Manual", under Section 6: Service and Appearance Care - Engine Oil...
Either try disconnecting thebattery for about 10 mins. or have vehicle scanned to determine the problem