tyleri
The best and fastest way to reset the instrument panel of 2004 Trailblazer is to disconnect both battery terminals. Reconnect them after about 30 minutes and everything should be reset.
press and hold the reset button on the dash panel
I used this procedure to reset my 2002 s40 services light (it should work for 2008 s40 also). a) insert ignition key and turn it to the 1st click - no lights on bottom of the instrument panel should be light up b) press and hold trip odometer reset button, and turn the ignition key to the 2nd click - the row of lights at the bottom of the instrument panel should come on c) after about 5 secs the lights should go off except the Service reset light - it will blink d) when the Service reset light has blinked for about 3 times - release the odometer reset button e) the Service reset is complete Note: This procedure cannot be used to reset Check Engine light - it requires an OBD2 code reader.
If they are all not working, I would suspect a blown fuse, or they are just turned off. There is a rheostat used to control the brightness of the instrument lights. If it is turned too far the lights will go off. Find the control and turn it. Sometimes it is the reset button for the odometer and sometimes it is a separate control. Look in your owner's manual for the location.
With the engine off, press and hold the mileage reset button on the instrument panel. Turn the key to "on" not start while still holding the button(10 to 30 secs.)It should reset the light. Don't reset this light without actually changing your oil though, that could be bad.
After changing the engine oil, the system must be reset. With the ignition key to ON (engine not running), push the RESET button located in the driver's side instrument panel fuse block. The CHANGE OIL light will start to flash, press and hold the RESET button again. The reset is complete when you hear the chimes and the CHANGE OIL light goes out.
My 2012 has a rest button on left side of instrument panel
there is a reset button in the fuse box next to the instrument panel. turn the key to on with thew engine off and press the button then the light should flash and hold the button till it chimes and it will go away
with the engine turned off hold down the trip meter button on the right hand side of your instrument panel (0.0) swith on the ignition but not the engine then when service now appears press the minute button on the left side of the instrument panel and it will reset.
To reset the service indicator Citroen C3, push the button on the instrument panel. Hold it for 10 seconds while turning on the ignition.
To reset the oil change lamp on a 2007 Town and Country, locate the reset button on the instrument panel. Hold the button down for 5 seconds.
Yes there is. You simply twist the tachometer reset nob counterclockwise to dim.