Antifreeze and Engine Coolant
Chevy Impala
Chevy Silverado
Chevy Venture

How do you reset low coolant light on 2000 Chevy impala?

212223

Top Answer
User Avatar
Wiki User
Answered
2008-01-01 02:10:49
2008-01-01 02:10:49

go to auto zone they will do it for you

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


You should be able to reset the low coolant light by the parking light switch 3 times on and off somewhat quickly should do it

Use an OBD scan tool to reset or disconnect the battery

The ABS light is on because there is a problem with the system. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself.

The abs light is on because you have a problem with the abs system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself.

With engine off. Turn key to on. Press accelerator fully three times. This should reset light.

turn the parking lights on and off 3 times

There is no way to reset the light. If the light is on, then either the coolant is low, the float is stuck or the sensor is bad.

Disconnect the negative on the battery terminal for 15 seconds.

disconnect your battery and then reconnect. The light should reset and turn off.

Make sure the coolant level is ok, add fluid if needed, that should make the light to go out if light still on you will probably have a bad coolant level switch and will meed to replace it

Take it to your Dealer for repairs. It could be any number of sensors or the contacts in the column.

Just disconnect the negative cable from your battery for a good ten to fifteen minutes so that the main does itself a reset.

Chevrolet does not use inertia/reset switches.

Listed in detail in your owner's manual. Don't have one then you need to get one.

Either try disconnecting thebattery for about 10 mins. or have vehicle scanned to determine the problem

Well, it will no light up if you have the correct coolant levels.

How do I reset the service engine light on a 2003 Chevy Trailblazer?

The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.

there is no reset you have replace the low coolant sensor and flush cooling system and use dexcool coolant.

Disconnect the neg battery cable for 10 mins.

How do you reset check engine light for the 2009 Chevy trail blazer?

See How to Reset the Change Engine Oil Message on page 6-18 of your "Owner's Manual", under Section 6: Service and Appearance Care - Engine Oil...

fill the coolant reserve and the light should go out


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.