The reset button is under your left leg, directly behind your knee air bag. It's a large black button with the tire pressure symbol next to it.
Air your tires to the appropriate psi for the 93V or 94V tires. After your tires have the appropriate PSI (usually 32 psi), then press the reset and start your engine.
The warning light may blink but should turn off within a few seconds; driving shouldn't be necessary, unlike many Hondas.
If it still doesn't work, check your spare tire. I know, it went against my thinking, but my light didn't go off with 32 psi on my 2010 Avalon Limited. I checked the spare and it was at 28 psi cold (should be 35 psi?). Anyways, aired it to 32 psi, reset the button, cranked the engine and, what do you know, a few seconds later my warning light went off.
Good luck to all those who read.
How do you reset maint read light on 2010 corolla
reset service light on 2010 ml 550
coaster bus how do you reset timing belt light 2010
the system is very sensitive to cold temperatures. it will trigger in very cold weather so all you have to do is raise the air pressure to the proper psi and the system will then register a new and proper reading and turn off the light. there is no reset.
Reset the device by debugging it.
The 2010 Toyota Avalon has 24 valves.
The 2010 Toyota Avalon has a V6 engine.
The abs light is reset with a scan tool after repairing the failure that caused the code.
The 2010 Toyota Avalon is a gas-powered vehicle.
Adjust the air pressure in the soft tire to the correct pressure and check the rest. A short drive will reset the light unless you have a fauly tire pressure sensor in one of the tires, then in that case the faulty sensor would have to be replaced by a garage equipped to do tires.
Set the tires to the pressure on the label on the drivers door jamb, and it should turn itself off. If it stays on, there is a sensor problem and it will require service.
Mine, a 2010 1.4 TSI VRS has a button down by the hand brake. Hold it for a couple of seconds