reset service light on 2010 ml 550
Resetting the maintenance service indicator on G.L.K 2010
To reset the low brake pad indicator on 2010 Ford Trans IT simply turn on the ignition and press the foot brake and the accelerator simultaneously. The accelerator and the foot brake should be pressed at the same time.
Service wrench on 2010 c 250
Just press the trip reset button
I Think its a main dealer job only as they use a guided function with the Audi VAS computer to reset the service display
Key on, engine off. Press the gas pedal to the floor three times in ten seconds.
The only way to clear the service light is by using a scan tool on the newer models.
Resetting the Service Reminder DisplayCaution!Do not reset the service reminder between service intervals; otherwise, incorrect information will be displayed.Switch off the ignition.Push and hold down the reset "0.0/set" button.Switch on the ignition.Release the "0.0/set" button and push the clock setting button within 20 seconds.
I believe you should wait until the service indicator drops to around 15%.
Turn the key on but do not start the truck then slowly press the gas pedal to the floor 3 times
this can only be done at a mitsubishi dealers service department
Turn the ignition switch to the ON (II) position.Press the select/reset knob repeatedly until the engine oil life indicator is displayed.Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to "100."NOTE: After the engine oil life and maintenance item codes start to flash (blink) you must RELEASE the reset knob and press again for another 5 seconds. It will then reset.