Want this question answered?
How do you reset the maintenance required light in the 2011Toyota RAV4 with a smart key starting system
With the engine and ignition off push and hold in the odometer reset button. While holding that button in, turn on the ignition but do not start the engine. After about 5 seconds the light will go off and the maintenance required light will have been reset.
Set it to trip A and hold reset turn ignition off then turn ignition on and maintenance light will flash and your done.
You will need to take it into a mechanic. They will be able to check out your vehicle and then they can turn off the light.
Turn key off. Push mileage reset button. Keep it pushed in while you turn ignition key to on position. Hold for 10 secs...
Turn the ignition key partially change display to "Trip A" and turn ignition OFF. Press the trip reset button and then turn the ignition key partially. Do not start engine. Hold reset button down until light goes off.
Two buttons on the left side of the steering wheel on the dash, square and circle marks. Press the square one go to maintenance, oil, reset; select using the other button.
It is very easy to reset the oil light after you had an oil change in your 2011 Ford E350. You will just need to disconnect the battery for up to 1 minute to reset the light.
asy
asy
You have to fix the cause of the code that turned the light on. It can than be reset with a scan tool.You have to fix the cause of the code that turned the light on. It can than be reset with a scan tool.
Use the button next to your odometer to set your odometer to the total mileage setting and hold it down. (not 'trip' odometer) Turn the ignition to the "acc" setting while holding the button. Do not crank the vehicle. Hold the position for five seconds (you will be able to see it flash dashes then turn to O then the mileage will reappear) then turn the ignition key off. Release the button. The maintenance light will be reset