Disconnect the negative battery terminal for 10 seconds then reattach. Codes will be cleared unless problem still exists.
No you would have to connect the car to a Computer(OBD1 Or ORD2) depending on the year of the car, and reset the code.
The code means hard faults present. This is a fatal code and will require replacement of a sensor or part. Could you tell us a bit more about the problem?
This is a fuel system malfunction on OBD1 hondas.
Considering this is a 1996 model, you can have either the OBD1 or OBD2 system. Most manufactures switched this year. If it is OBD1 then disconnect the battery for 5 min and it should reset. If it is OBD2 it can only be reset with a scan tool. Some OBD1 systems were also reset with a key combination. Call your local Ford dealer and they will inform you of which you have and the procedure.
OBD1 code 41 = solenoid valve, vehicle speed control
for obd1 or obd2? usaully it just means that the o2 sensor is bad and not getting accurate readings therefore making your car run either lean or rich
No. OBD1 = CPS.
According to the Haynes manual, code 13 means "MAP sensor vacuum circuit" and will activate your Check Engine light.
Speedsensor
What does a code 212 mean on a OBD 1 mustang
tps signal out of range
Try disconnecting the battery for 1 hour. This should reset the check engine light on this vehicle as it is OBD1.