0
What else can I help you with?
If you replace the map sensor eliminate the code?
No you would have to connect the car to a Computer(OBD1 Or ORD2) depending on the year of the car, and reset the code.
Where is the obd1 connector for 1991 Acura Legend?
standing in front of the car on the left hand side by the engine it should be grey, remove the cap and plug in the obd1 reader. hope this helps.
What is Honda obd1?
obd1 is basically a computer system in your car there is obd1 and obd2. obd1 is 1996 and earlier while obd2 is 1997 to now
Where is code reader or ob on 1994 accord?
There is no OBD2 connector on a 1994 Honda Accord. Your car is not OBD2 compliant. You car is OBD1. Click the link for detailed instructions with photos on how to retrieve the code.
What is OBD1 System in a 95 Lincoln Town Car?
Obd1, not obdi--is accurate to describe the system used to check the electrical and engine systems on the car.
Was the 1991 Plymouth Acclaim a K car?
No it was had an AA body code.
What is the O2 sensor code 21 on the Scantool?
for obd1 or obd2? usaully it just means that the o2 sensor is bad and not getting accurate readings therefore making your car run either lean or rich
Is a 1995 thunderbird 4.6 use a obd1 or obd 2 to check car?
1994+ is obdII
Can you determine where your 1991 Dodge Dynasty was originally purchased if you know the VIN code?
All you will know from the VIN code is what plant built the car. The VIN doesn't show anything about where the car was sold from.
What does error code 27 on 1991 sedan deville mean?
It is important to know the meaning of codes coming off of a car. The Code 27 on a 1991 Sedan Deville means Open circuit in throttle switch.
Can transmissions be interchanged 96 bretta into a 93 cavalier?
No, one car is OBD1 and one is OBD2, they will not work.
Obd2 y8 swap into obd1 eg need help?
I have a 1993 civic ex coupe.Ive looked this up but noone has a clear answer i put the Y8 in my car.Put the OBD1 alternator on and OBD1 injectors ive converted the Dizzy to OBD1 but i have three extra plugs on my wireing harness left over and car will not crank or anything.I used the Z6 wireing harness.So all i know to do is Put a Z6 intake manifold on? any suggestions.
