For the Passlock 2 system, put the key in the ignition and turn the engine over (the car should not start, if it did you are done), turn the key to the ON position, let it set for 10 min. The security light should be flashing. After 10 min. the security light should stop flashing the car is ready to learn the new key value. Turn the key off, wait 5 seconds, and then try to start the car.
the 1999 venture has the PK3 system for security, so you have to go to a GM dealer or a automotive locksmith that has the proper box to reset it or make a new master key for it.
how do you bypass passlock on 2002 Chevy impala
wait 10 minutes for the passlock system to reset for a GM vehicle.
cut the yellow small wire from ign. switch in the column up by the switch. this is the passlock wire. but will it start iwas told that it wouldnt
to reset anti theft system ( passlock ). turn key to on engine off, leave on for approx. 10 minutes. after 10 minutes turn key off, wait 15 seconds then start car. here is a site to disable system for good! tubesound.com/passlocksystem--just type in problem when page comes up or year of car. have a good day!!
To reset the Passlock system on a 2003 Chevy Impala, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave the key in this position for about 10 minutes until the security light turns off. Then, turn the key to the "Off" position for a few seconds and repeat the process two more times. After the third cycle, the Passlock system should reset, allowing you to start the engine.
Turn the engine two seconds then leave the key in the run position for exactly ten minutes...the anti-theft security light should go from blinking to solid at the ten minute mark. Immediatly run the engine and the Passlock is reset. Good Luck!!
gand mense your bumps
Depends on the vehicle and manufacturer. On GM Passlock, you have to wait about 10 minutes for the system to automatically reset before you try it with the key again.
There are a myriad of possible "solutions" available. If you are even just a little bit technically savvy you can with a little bit of effort disable and or bypass the "passlock" system. Just Google Chevy impala passlock disablement or Chevy impala passlock bypass. There are several ways to do this and it would be better for you to read all the information available and arrive at your own decision. This seems to be a "VERY PREVELENT PROBLEM"
Your Passlock Module is acting up.
No, a 1999 Dodge does not have a reset button.