answersLogoWhite

0

Turn the engine two seconds then leave the key in the run position for exactly ten minutes...the anti-theft security light should go from blinking to solid at the ten minute mark. Immediatly run the engine and the Passlock is reset. Good Luck!!

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the passlock sensor located on a 2001 Saturn l200?

sensor is located in the ignition housing itself and can not be serviced seperatly from the housing, it must be replaced


What is the function of a passlock sensor on a 2001 Saturn l200?

security to hamper theft. It prevents "smashing" the ignition cylinder to turn the steeering wheel


Where is the fuel reset switch on a 2001 L200 Saturn?

odometer button


How do reset the security system on a 2001 Saturn ls1 after battery change?

H


How do you reset passlock for 2001 Chevrolet Impala?

There are a myriad of possible "solutions" available. If you are even just a little bit technically savvy you can with a little bit of effort disable and or bypass the "passlock" system. Just Google Chevy impala passlock disablement or Chevy impala passlock bypass. There are several ways to do this and it would be better for you to read all the information available and arrive at your own decision. This seems to be a "VERY PREVELENT PROBLEM"


How do you reset the check engine light on a 2001 Saturn SL2?

Repair the problem and it will typically reset itself after 3 starting cycles.


Where is the reset switch for the fuel pump located on a 2001 saturn 4D?

It is not equipped with an inertia switch.


Where is BCM located on 2001 Saturn SC2?

how to use bcm to reset change oil light


The car will not start and the horn honks and lights flash; how do you reset?

wait 10 minutes for the passlock system to reset for a GM vehicle.


How to reset the passlock on 1998 Chevy 1500?

cut the yellow small wire from ign. switch in the column up by the switch. this is the passlock wire. but will it start iwas told that it wouldnt


How do you reset passlock on a 2003 chevy impala?

To reset the Passlock system on a 2003 Chevy Impala, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave the key in this position for about 10 minutes until the security light turns off. Then, turn the key to the "Off" position for a few seconds and repeat the process two more times. After the third cycle, the Passlock system should reset, allowing you to start the engine.


How To Reset Security System on 2006 Saturn Vue?

how can I reset the security system on my 06 saturn vue