press and hold right button (3)
Turn ignition ON
10second countdown
Release button at end of 10secs
Turn Ignition OFF
anybody have any info on a 2009 ml320 how to reset service message?
Go get it serviced.
see:- http://grumunkin.blogspot.com/2009/08/how-to-reset-service-indicator-on.html :-)
2009
You don't!
Most likely you will have three buttons labeled INFO-SETUP-RESET on the inside of your vehicle. If you press info until you get to the indicator for Oil Life, you should be able to press and hold reset to...reset it. Please refer to your owners manual in future cases
It is a fault detected by the module.
2009 models can be reset using the centre display panel going to "car-settings" and just scrolling down, it will not alter the long life service, for that you need a scanning tool.
Manual Service Reset • Range Rover (L322) (2002 - 2009) (except Japan and North America) 1. Switch ignition OFF. 2. Press and hold button A. (Note: button A is situated in the instrument cluster between Speedometer and Fuel indicator) 3. Keep button depressed and switch the ignition to position I. 4. Keep button depressed for five seconds until 'SIA RESET' appears in the LCD display. 5. The display will now indicate the distance to service and the type of service required (OIL SERVICE or INSPECTION). 6. Check the distance to service has been reached. If it hasn't, please proceed to the next step. If it has, please proceed to step 9. 7. Press button A once. The display will show the date to service. 8. Check the service date has been reached. If it has not, please proceed to step 10. If it has, please proceed to step 11. 9. When the distance to service has been reached, press button A for 5 seconds. 'RESET' will flash on the display. Press button A again before 'RESET' has flashed 5 times to reset the service distance limit. The new distance to service will be displayed for 5 seconds before the service date is displayed. 10. Press button A once to end the service interval check and reset. 11. When the date for service limit has been reached, press and hold button A for 5 seconds. 'RESET' will flash on the display. Press button A again before 'RESET' has flashed 5 times to reset the service date limit. The new date to service will be displayed for 5 seconds before end service is displayed. 12. Switch ignition OFF
Have vehicle scanned to determine the problem and then repaired
You will need to take the 2006 Audi A6 to a mechanic to have the service light properly reset. In some cases, a person can undo the battery to reset the light.
Turn the ignition on, with the engine off. Press the gas pedal to the floor three times in ten seconds.