0
How do you reset the abs light on the dash after new brakes were installed and it won't go out?
Wiki User
∙ 14y ago
An ABS light after a brake job could indicate that the technician disconnected a wheel speed sensor, or even just did not properly clean it. It could also be caused by the caliper piston being forced into its bore without opening the bleeder screw, which forces sediment from the caliper into the ABS valve body, potentially causing problems.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you reset brake light on dash after brakes and sensor has been changed on a 2007 328i?
Disconnect the battery for 15-30 Mins and it will reset automatically.
How can you reset the dash light blinking light on a 528 BMW after all bulbs have been replaced and reset the brake warning light after new brakes have been installed?
if it is your brake light blinking then you may need to check the rest of your braking system ,, ie. fluid level,pressure switch, and wear sensors... Turn your ignition key to position 2 (do not start the car). Wait approximately 45-60 secs. and it should reset the yellow dash light.
What is wrong when your brake light on the dash lights up and you have no brakes but when you repress the brakes the light goes off and your brakes are back?
check fluid level
How do you reset the brake light on the dash to go out on a 1995 Trans Am?
Basically fix the problem with the brakes, check to see that the fluid is full and if it is you need to get the complete brake system checked out.
Blinking brake light on your dash what does this mean?
your park brakes are on
How to reset SRS light 2001 Hyundai Elantra?
airbag light is on dash
1989 Jeep and the red brake light in the dash stays on all the time brakes have been replaces how do you get this light to go out?
you have air in your brakes bleed them
After changing brakes on a 1990 Acura Legend the Antilock light will not go out?
check your fluid levels, some vehicles will need brake bleeding but some may have brake sensors which that light that is lit up on your dash is for when the brakes were replaced the sensor may not be installed correctly go back and replace the sensor
Why is the abs dash light on for my 2002 ford explorer?
It could be a fuse , a sensor , or some other problem with the anti-lock braking system ( as long as the " brake " light in your dash is not on , you still have " normal " braking ) it means air brake system and it has something to do with your brakes. unhook the battery cable and let it reset and that will tell you for sure if you have something wrong let it reset for 15 minutes
What is a black box under dash of Holden Vl commodore with switch and red light connected to brakes?
Trailer brakes.
How do you reset the brake light and the ABS light on the dash of a 1997 dodge Dakota?
After repairing the failure that caused the code, the lights will reset themselves.
Light on dash for low tire pressure 2009 Toyota corola?
how to reset tire light
