answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2009-07-24 21:50:29
2009-07-24 21:50:29

remove the neg wire to the battery and leave it off for 15 minutes

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do you adjust the parking brake on a1994 Lumina?


It is quite easy to install the 1992 Chevy Lumina brake light switch. The brake light switch simply plugs in and out.


The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.


Remove the tire and wheel from your 1994 Chevy Lumina. Remove the brake spring and the break caliper. The brake pads will come off. Reverse the process to install the new brake pads.


I have a 92 lumina 3.4 Mine was above the brake peddle


Purchase the Haynes Manual for the Lumina it has all diagrams you may need.


possible air in the brake lines.


Usually at the upper end of the brake pedal under dash



Begin by removing the tire and wheel from your 2000 Chevy Lumina. Remove the brake spring and the break caliper. The rear brakes will come off.


brake light switch, it is typically located above the brake pedal somewhere on the brake pedal arm


Remove the tire and wheel from your 1993 Chevy Lumina. Remove the brake assembly spring and the brake caliper. The brake assembly will come off. Tap on the rotor with a hammer or mallet. The rotor will slide off. Reverse the process to change the new rotor and brakes.




press to release. says so right on the pedal.


The 1990 Chevy Lumina signal flasher unit can be found beneath the drivers side dashboard. The signal flasher unit will be above the brake pedal.


Your problem may be with any or all of these three items: The fuse, brake switch or bulbs in the brake lights.


You can reset the brake warning lights, on your VW Jetta, by backing up 20 feet and using the brakes. The automobile will sense the new pads and the warning light will go off.


turn signals work butt the brake lights dont can anyone help please? cant afford a mechanic.


Did you try changing the bulb? It might be burned out.


Changing the brake light relay switch on your 1999 Chevy Cavalier is quite easy. The brake light switch simply plugs in and out.



Its most likely the brake switch. Its a plunger like switch on the brake pedal. Its pretty easy and cheap to change.


It means there is a problem with your brake system. Can be it is just low of brake fluid or can mean something more serious. Do not ignore this warning.


By repairing the problem. Low brake fluid, defective master cylinder, etc.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.