Chevy Silverado

How do you reset the change oil light in a 2001 Chevy Silverado?

909192

Top Answer
User Avatar
Wiki User
Answered
2015-07-16 19:22:53
2015-07-16 19:22:53

Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


key on engine off press accelerator pedal to the floor five times very rapidly should reset

No there is not. Chevy did not use them on there trucks.

Disconnect the negative on the battery terminal for 15 seconds.

Turn the key to the on position but do not start press the gas pedal 3 times within 10 seconds and the oil change light will flash 3 times and go out. now it is reset

You use a scan tool after repairing the cause of the code that turned the light on.

Chevy does not have a reset button, Ford is the only one that used those.

try disconnecting the battery that resets your computer

Chevrolet does not use inertia/reset switches.

Chevrolet does not use inertia/reset swtiches.

Chevrolet does not use inertia or reset buttons.

turn the key to the run position and slowly pump the gas pedel 3 times and it will reset. Thanks JLamond219

GM vehicles do not use inertia/reset switches

GM vehicles do not use inertia/reset switches

battery dicunnect for 3 min. or take to auto parts store and have cleared

After you change the oil, turn the key to ACC or ON but do not start it. Then press the gas pedal 3 times within 5 seconds. The sensor will then reset itself. chiefy98clg at yahoo dot com

How do I reset the service engine light on a 2003 Chevy Trailblazer?

Turn the key on but don't start the car, depress the gas pedal completely to the floor three times within 5 seconds, turn key off and then start car. If you were successful the light should flash 5 times then go out. This should reset it, works for almost all newer GM's This is how you reset the light if your vehicle does not have the steering wheel controls. If it does, you reset the light with the steering wheel controls.

The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.

With engine off. Turn key to on. Press accelerator fully three times. This should reset light.

Turn the key to "on" but do not start the engine. Push the gas pedal to the floor 3 times in quick succesion. The change oil will flash 3 times to let you know it has reset.

How do you reset check engine light for the 2009 Chevy trail blazer?

you turn the ignition key just to on and hit the gas pedal 3 times in succession then the oil light should flash 5 times and it will be reset after that...

when you disconnect your battery and reconnect it will reset cumputer

to reset an injector , is a specialist job if injector is faulty, it needs replacing


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.