0
How do you reset the computer on 2015 Chevy Silverado after changing the oil?
Wiki User
∙ 7y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you reset computer on 2002 Chevy Silverado?
You will have to have a obdII engine scanner to do that. some parts stores will do it for free.
Is there a reset for the 2003 Chevy Silverado fuelpump?
No there is not. Chevy did not use them on there trucks.
How do you reset computer after changing oil on a Chevy Silverado?
On my 2003 silverado I turn the key to the on position and press the gas pedel all the way to the floor 3 times. On the dash it will pop up the message "change oil" then it will pop up the message "oil life rest".
Where is the Fuel pump reset for a 2000 Chevy silverado?
Chevy does not have a reset button, Ford is the only one that used those.
How do you reset computer after changing battery for BMW 745li?
do you have to reset computer after changing battery in 2003 745li
Do you have to reset anything after changing battery on a 2002 silverado?
Radio presets.
Where is the fuel pump reset on a 2005 Chevy silverado?
Chevrolet does not use inertia/reset switches.
Where is the fuel reset button on a 2000 Chevy Silverado 1500?
There is not a fuel reset or cut off button or switch on a Chevrolet. There is a relearn if power is lost or the computer is reprogrammed. This will NOT keep the vehicle from starting.
How reset computer after changing battery 2005 BMW x3?
You do not have to reset the computer.
Where is the fuel pump reset switch on a 2002 Chevy silverado?
Chevrolet does not use inertia/reset swtiches.
Where is the fuel pump reset button for 07 Chevy silverado?
Chevrolet does not use inertia or reset buttons.
How do you erase a Chevy silverado 2001 when light is on incheck engine?
I also have a 2001 Silverado and whenever I want to reset the computer I just disconnect the battery for awhile. It usually takes about 30 minutes for the computer to reset. Be aware however that this will not fix whatever caused the failure to begin with. If the problem still exists, It will reappear again.
