When you install a new ignition switch, you should disconnect the battery. That will perform a computer code reset. If you are still getting codes, something is wrong. Check your wiring and make sure everything is properly connected and not shorted. Check the computer versus security system synchronization, particularly the key code sensor which is near the ignition switch. Make sure you did not break any of the conductors in the "clock spring" that connects the steering column with the rotating parts of the steering wheel. See the manufacturer's documentation for specifics.
The ignition switch in a 2004 Pontiac grand am can be installed by first Sliding out old lock cylinder and then Press the small release tab While turning the key to the ON Position.
Ignition switch.
How is the ignition key switch replaced on the 2000 Pontiac Sunfire? And after replacing the switch would I have to have it Towed to the Pontiac Dealer in order to have the car key programed to the Computer?
Begin by removing the retaining ring at the top of your 1990 Pontiac Bonneville ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.
How do you replace the ignition swith opn a 1992 Pontiac Bonneville se
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.
pull it really hard
no
ignition switch or key and tumbler.
On the column accross from the key lock cylinder
What, exactly, is the problem?