answersLogoWhite

0


Best Answer

1. As soon as the engine starts, idle the engine in drive for two and a half minutes with the A/C and rear defrost on. (OBDII checks oxygen sensor heater circuits, air pump and EVAP purge.)

2. Turn the A/C and rear defrost off, and accelerate to 55 mph at half throttle. (OBDII checks for ignition misfire, fuel trim and canister purge. )

3. Hold at a steady state speed of 55 mph for three minutes. (OBDII monitors EGR, air pump, O2 sensors and canister purge. )

4. Decelerate (coast down) to 20 mph without braking or depressing the clutch. (OBDII checks EGR and purge functions.)

5. Accelerate back to 55 to 60 mph at half throttle. (OBDII checks misfire, fuel trim and purge again.)

6. Hold at a steady speed of 55 to 60 mph for five minutes. (OBDII monitors catalytic converter efficiency, misfire, EGR, fuel trim, oxygen sensors and purge functions.)

7. Decelerate (coast down) to a stop without braking. (OBDII makes a final check of EGR and canister purge.)

User Avatar

Wiki User

โˆ™ 2009-01-01 20:58:02
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reset the drive cycle on the OBDII computer on a Honda civic?
Write your answer...
Submit
Related questions

How do you reset the drive cycle on the computer of a Honda element?

You take out the battery and reinsert it.


What is the OBDII drive cycle for a Jeep Wrangler?

The average Jeep computer takes about 20-30 minutes of driving to perform all the required tests.


How do you reset the obdii drive cycle on 2003 Mercedes Benz e500?

How do you reset a e500 mercedes benz drive cycle


How do you reset the drive cycle on the OBDII computer on a Toyota Highlander?

Disconnect both cables on battery, hold horn down for abouta minute, reconnect battery about 15 minutes later


Where can you get parts for a CL 77 Honda?

Ohio Cycle and Western Hills Honda


How do you pass vehicle inspection for 97 Honda accord ex V6 motor when test says status not ready?

You need to run the car through it's drive cycle before the computer can perform all of it's emissions tests. Look up the drive cycle specified by Honda, perform the drive cycle, and then it should be all set.


What would cause a 1998 Honda Civic air conditioner to cycle doing a great job for approx 20 min. then blowing hot air for approx 20 min Cycle continues over over on long trips?

Sounds like you are getting low on freon


What is the Obd2 drive cycle for 1993 Honda Accord?

1993 honda accord is obd1 not obd2


Describe how the computer can conduct the information processing cycle?

describe how the computer conduct the information processing cycle


How do you reset the check engine light on a 1996 Toyota Camry?

Go to eBay and search "obdII" and buy one, they run about $50.00 including shipping. There are two types, ISO for Chrysler and some Japanese, and the other one for all the others like Ford and GM. There are several that are both, that is the kind you want. Be sure to email the eBay seller and ask if it is used with your year and model. (1996 was a changeover year for OBDII technology, so this advice may not apply to you--but the Toyota dealer service guy can tell you over the phone--ask him if it is OBDII compliant.) When you get it, you just plug it in and let it cycle 4 or 5 times and it resets everything. You then have to drive your car for 50 to 100 miles for the onboard computer to test everything, and in the meantime your car will fail smog checks because it has no history in the computer and the smog test procedure demands a history even if there is no pollution. Cut and Paste http://search.ebay.com/OBDII for a list of them for sale on eBay. Go to eBay and search "obdII" and buy one, they run about $50.00 including shipping. There are two types, ISO for Chrysler and some Japanese, and the other one for all the others like Ford and GM. There are several that are both, that is the kind you want. Be sure to email the eBay seller and ask if it is used with your year and model. (1996 was a changeover year for OBDII technology, so this advice may not apply to you--but the Toyota dealer service guy can tell you over the phone--ask him if it is OBDII compliant.) When you get it, you just plug it in and let it cycle 4 or 5 times and it resets everything. You then have to drive your car for 50 to 100 miles for the onboard computer to test everything, and in the meantime your car will fail smog checks because it has no history in the computer and the smog test procedure demands a history even if there is no pollution. Cut and Paste http://search.ebay.com/OBDII for a list of them for sale on eBay.


How many carburetors does a Honda shadow 750 have?

A Honda shadow 750 V twin motor cycle has two carburators.


Is a 1997 Honda 50 r mixed fuel?

No, it is a 4 cycle.


What is the instruction cycle?

The instruction cycle is the basic operation cycle in a computer. This is what will take in data, process it and execute as required.


How long do you wait after computer is reset to get inspected?

On my ford, it tells me how to cycle the computer OBDII. start vehicle till its warm enough. idle vehicle for 80sec then drive vehicle to 30-45mph at half open throttle for 3-4mins then go back to idle for another 80 sec then repeat step 5 times. its actually hard to follow when driving on the street. take your vehicle to the highway and just drive for like 20 miles(normal driving) it should cycle by then.


What oil goes in the 1987 Honda Rebel 250cc?

The recommended oil type for a 1987 Honda Rebel 250 CC is 10 W 40. This cycle oil can be purchased at any cycle shop or auto parts store.


What happens if I mixed 2-cycle oil with 4-cycle oil in a Honda engine?

You will cause severe engine wear.


What do you mean by ipo cycle in computer organization?

An IPO cycle is a business term, as far as I know.


Explain the Information Processing Cycle of a computer?

nA computer is an electronic machine that performs the information-processing cycle.nThe information-processing cycle consists of 5 operations: input, processing, output, storage, and communication.


What fetches and decodes instructions in a computer?

An instruction cycle.


How does the CPU know which instruction to execute next?

An instruction cycle (sometimes called fetch-and-execute cycle, fetch-decode-execute cycle, or FDX) is the basic operation cycle of a computer. It is the process by which a computer retrieves a program instruction from its memory, determines what actions the instruction requires, and carries out those actions. This cycle is repeated continuously by the central processing unit (CPU), from bootup to when the computer is shut down.


Different phases of instruction cycle?

The phases of a typical computer instruction cycle are fetch, decode and execute. The instruction cycle is also known as the fetch-and-execute or FDX cycle.


Explain instruction cycle?

An instruction cycle is the rudimentary operation cycle of any computer. It involves the CPU fetching a program from memory and executing it fully.


How do you turn off the check engine light on a Honda S2000?

Two parts to the answer - theory first - Fix problem and then drive car through a "drive cycle". The sensors are checked on a periodic schedule by the computer. Drive cycle is the number of miles driven it takes for the computer to do the next check on the sensor related to the repair. I do not know the miles for the s2000, but typical is 100 miles. Part 2 - If passing inspection is the issue, the auto parts house can reset your light with their computer code reader, but the computer will not show the sensor in question as "ready" until the repairs are made and the drive cycle is complete. In most states, the computer must show "ready" in all categories to pass inspection.


What is the horsepower of a Honda v65 magna?

See related link from Cycle Magazine. 105hp


Where can one purchase a used Honda CT110 from?

One can purchase a used Honda CT110 from the following retailers: Trading Post, eBay, Bike Sales, Trial One, Bike Nut, Cycle Trader, Pipe Burn, Motor Cycle, to name a few.