0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the ECM located on a 1989 through 2002 Isuzu Rodeo Amigo or Honda Passport?
Isuzu rodeo 3.2 V6 LS.
What is the ecm on a 2000 Isuzu rodeo?
ECM stands for Engine Control Module (computer that controls the engine and other ). For 2000 Isuzu rodeo v6, this is located on the left side of the car under the hood . right behind the air filter enclosure
99 Isuzu Rodeo 3.2 to 3.5 engine swap do you need to swap the ecm as well?
no works just fine with the 3.2 ecu
Location of the electronic control module on a 1997 Isuzu Rodeo?
If you are speaking of the PCM(Power Control Module) or ECM(Engine Control Module, it is located in the inside middle of the dash. There is also a ECM relay in the underhood fuse box.
Where is the ECM 95 Isuzu rodeo to check the check engine light?
IFF YOU MEAN THE PLUGS FOR THE ECU TO CHECK YOUR CODE IT IS LOCATED NEAR THE HOOD OPENRE ON TEH BOTTOM BEHIND THE TRIM
Where is the TCM on 1994 rodeo Isuzu?
On mine, it's on the driver's side, just inside the front door, left side under the dash behind a plastic panel. The ECM is there as well and the TCM is just above it.
What could cause Check Engine light to blink while accelerating but go off when coasting or braking on 2002 Isuzu Rodeo?
possibly a transmission code from the ecm. i would have this checked soon. transmission damage possible.
How do I reset the ecm in a 1989 Chrysler new yorker 3.0l v6?
You can reset the ecm with a scan tool or by unhooking the battery.
Where is the location ecm on a 1996 Nissan maxima?
were is the location ecm on a 1996 Nissan maxima
Idle setting for 1995 Isuzu Rodeo 3.2lt 4wd?
u dont set the idle the ecm does the setting througt the air idle conrtol. If it wont idle u need to replace the aic motor on the th0rottle body!
How to reset ecm in 1995-1997 chevy tahoe with 5.7?
Just unhook the battery cables for 5 mins, That will reset the ECM
How do you reset the computer on a 1999 dodge 2500 cummins?
To reset the ECM remove the battery cable (s) for a few minutes. Replace cable. ECM has been reset.
