0
How do you reset the oil change lamp on a 2007 town and country?
Wiki User
∙ 9y ago
To reset the oil change lamp on a 2007 Town and Country, locate the reset button on the instrument panel. Hold the button down for 5 seconds.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you replace fog lamp bulb on a ve commodore?
eazy way to change fog lamp on ve commodore 2007
How do you reset oil change light on Toyota dyna?
The Oil Change lamp is a 'Change Oil' warning lamp, not a 'Service Interval Indicator' lamp. When illuminated, the Oil Change lamp indicates that the scheduled distance for changing the engine oil and filter has been exceeded. It does not indicate when the vehicle requires servicing. Remove the grommet above the fuel gauge from the 1. instrument panel. 2. Switch ignition ON. 3. Using a suitable tool, press the button behind the grommet to reset the lamp. 4. Refit the grommet to the instrument panel. 5. Switch ignition OFF.
How can you reset your maintenance reminder light on your 1995 Ram 3500?
The SRI lamp may only be reset with the use of a DRBII scan tool, or equivalent. If this is not available, you will have to take the vehicle to a properly equipped shop for them to reset the lamp.
Is a lava lamp a chemical or physical change?
A lava lamp is a chemical change
Why doesnt brake lamp failure lamp on dash of 94 Honda Accord not reset after bulb replacement?
Remove the negative battery terminal (-) for about 15 minutes and most codes will reset.
What is a mood lamp?
a mood lamp is a lamp that can change a mood in a room
How do you change the brake lamp in a 1998 Lincoln Continental?
Which brake lamp are you needing to change? Brake/turn signal lamp.
How do you reset the brake lamp failure message?
replace the burnt out bulb
How can you reset malfunction indicator lamp?
To reset your malfunction indicator lamp start your car then you hire fps russia to blow up your piece of terrible car and buy a new one simple actually.feces
How do you reset oil change lamp 2005 Pontiac?
try turning the ignition key to on (don't start) and depressing the gas pedal 3 times within 5 seconds.
How do you reset maint req light 2007 corolla?
MAINT REQD on means its time to replace your engine oil. The indicator lamp stays on until it is reset. To reset this reminder: While the ignition switch is on, but the engine is not running, move the trip selector to ODO. Push and hold down the trip selector push knob. Turn off the ignition switch, then turn on the switch. The reset will go through 000000.0 then ------, -----, ----, ---, --, -. once it runs through, release the trip selector knob. The MAINT REQD lamp goes out.
How do you replace the fog lamp bulb on Kia Sedona 2007?
How do you replace the fog lamp bulb on Kia Sedona 2007?Read more: How_do_you_replace_the_fog_lamp_bulb_on_Kia_Sedona_2007
