0
What else can I help you with?
Why is the gas light always on in 1996 mercury villager where the sensor has been changed twice?
The indicator was not or cant be reset.
You have replaced the O2 sensors in your 1998 Mercury Mystique how do you reset the check engine light w no diagnostic scanner?
I have a 98 mystique, and when the check engine light comes on, I simply disconnect the positive battery terminal for a couple of minutes. When I replace it, the check engine light is cleared. It resets the computer.
Where is the reset button on a 97 mercury mystique?
The reset button for the fuel pump is in the drivers footwell , behind the kick panel ( there is an access hole )
Why does the OD light in a 1996 mercury mystique flash?
because you have a problem with your transmission and it is now in limp mode.it is probley shifting hard into each gear to.. need to flush trans and reset computer
How can I reset a motion sensor light?
To reset a motion sensor light, turn off the power to the light at the circuit breaker for a few minutes, then turn it back on. This should reset the sensor and allow it to function properly again.
How do you reset the Tire Pressure Sensor Default light on a 2009 Ford Focus?
hi how do i reset tire pressure sensor light on
How do you reset the oil light on a Chrysler PT Cruiser?
It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.It does not have a reset. If the oil light is on, the sensor has failed or the oil pressure is too low.
Where is the fuel pump reset button on a 1995 mercury mystique?
In a ( 1996 ) Mercury Mystique the fuel pump shut off switch ( inertia switch ) is in the drivers footwell behind the kick panel by your left foot . There is an access hole through the panel
How do you reset your coded keys on 2000 mercury mystique?
To reset the coded keys on a 2000 Mercury Mystique, you'll need to use the ignition key and the on-board computer. Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off, then turn the key back to the "Off" position and repeat the process for a total of three cycles. After the third cycle, your coded key should be reset, and you can test it to ensure it works.
How do you reset the timing on a 1998 mercury mystique?
To reset the timing on a 1998 Mercury Mystique, first ensure the engine is off and cool. Disconnect the negative battery cable, then remove the timing cover to access the timing marks on the crankshaft and camshaft. Align the timing marks according to the specifications in the service manual, and adjust the distributor if necessary. Finally, reassemble the timing cover, reconnect the battery, and start the engine to check the timing with a timing light.
What is wrong when you rear abs and brake light sensor stays on in your 1995 rodeo?
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
Will 02 sensor make engine light come on?
Yes, replace the sensor and have the dash light reset.
