you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
When the ABS and Brake light come on, it means there is a problem in the ABS and Brake system. If the issue is resolved and the light stays on, a person can use a scanner and clear this light.
IS it the BRAKE LIGHT or the Parking Brake Light? If it is the BRAKE LIGHT, then your pedal must be going down far enough to hit a sensor that sets off the brake light to tell you your brakes need serviced. Normally this means you are low on brake fluid. If you are low on brake fluid FIND OUT WHY! You may have excessive brake pad wear, or a leaking brake cylinder, or your master cylinder may be going out. If you keep pumping the brakes and then stand on it hard, feel for the pedal to eventually go soft, if it does, then normally the seals in the master cylinder are going out. If you pump the brakes and the pedal never gets hard, then you have a serious brake fluid leak. If the Parkign Brake light stays on, then your parking brake is not fully releasing, at least where the contacts are to remind you it is on. This can be adjusted.
The dealer will know how to access the codes for the brakes. When that is fixed it should not lock up then.
my brake lights stays on wile driving how can i fix it
It sounds like your VSS(Vehicle Speed Sensor) has gone bad, which will turn on your check engine light.
Check your brake fluid. You may need to replace a speed sensor on one of the brake assemblies.
emergency brake light stays on
EGR or Mass air flow sensor
it might be the sensor or the brake bars are worn out if there is abs on the car and it is also on you could try cleaning all sensors with wd-40 or high quality brake cleaners
The four wheel drive light is most Likely staying on when your Isuzu Rodeo is in two wheel drive because of a bad sensor. A licensed auto technician would be able to replace this for you.
Defective or misadjusted, brake light switch.
The battery light stays on when the alternator is over or under charging. The red brake light stays on when the parking brake is set or the fluid is low. The abs light stays on when the abs computer detects a malfunction and sets a code.
brake light swith located under the brake pedal is stuck.
The brake lights work without the key on, so you have a problem with your brake light switch.
A bad brake sensor can cause the ESP light to stay on in an Audi. Other reasons the light stays on include a problem with the batter, loose clamp causing a leak in the intake, and worn brake pads.
It could be brake fluid, badly adjusted emergency brake sensor, some other problem with the brakes... a dealership code scanner can tell you what's wrong.
no