RESETTING OIL SERVICE INDICATOR:
If your OBC needs to be reset after completing your oil change, there are two ways. NOTE: If you miss a step, just turn the key back off and try again:
A. Model Year 1999 to Mid-2000: You should have the older round 20-pin DLC connector under your hood behind the battery terminal, you need to use a small length of wire to connect (short) pins 7 and 19 for 3-5 seconds with the ignition key in position 1 (Accessory).
B. After Mid-2000: You should not have the 20-pin DLC connector. You only need to hold the left odometer reset button while turning the key to position 1 (Accessory). Keep holding the button for 5 or so seconds until any of the following shows in the display: OIL SERVICE or INSPECTION with RESET or RE. Release the button and press it again for another 5 or so seconds until RESET or RE flash. While the display flashes, press the button one more time briefly. If done correctly, END SIA should show up for a few seconds. All done.
How do you reset the oil service warning light manually on a 2003 BMW 525i?
How do you manually reset the oil life monitor on a BMW 525i
To reset the oil service light manually on a 1996 BMW 318i, disconnect the battery. Leave it unhooked for 10 to 20 minutes.
Dealer
I reset the FSS by refering to the Owner's Manual.
You will first need to properly reset the light. If this does not reset the light, then you may have to manually press it.
Ground out the # 7 pin in the data connector for 5 seconds. With the key in the acc position. Ground it out for 10 seconds to reset service light. BE SURE ITS THE RIGHT PIN. there numbered. EchoSai
how to reset manually edc light mercedes benz sprinter 311
Hiw do you reset a service light j2
How many quarts of trans oil doze my 2010 528i bmw hold and type of trans oil
you can ground out one of the pens in the diagnostic port.[different ports for different models]
How do you reset service light in 2003honda pilot