Timing Belt Warning Indicator Reset Procedure
a) Turn ODO/Trip Meter to ODO and turn the ignition switch to OFF
b) While pressing the trip switch, turn the ignition switch ON and hold for 5 seconds.
c) Release the trip switch, then press the trip switch again within 5 seconds.
d) Transfer to T-Belt mode. The initial setting value "15 (0,000km)" is displayed.
HINT:
Every press of the trip switch adds 10,000kms and the meter reading returns to 10,000kms when 200,000kms is reached.
If the switch is not operated for more than 30 seconds, the setting value will not be changed, the display screen turns to ODO, and the mode return to normal
timing belt light hilux 1kd
how to reset toyota kdn165 timing light
see hpoc.co.uk for a post on this very question
To reset the fuel filter warning light off for the Toyota hilux one must replace the filter that switch the car on and off. They must also click the rest button.
there is a little bung on your dash board beside your trip meter pull out bung and deep in there you will see a little button get a needle and push the button easy as that timing light out
There are a couple of ways to reset the timing belt light on a 2008 Toyota Hilux diesel. One way is to unplug the battery for up to five minutes and see if that will reset the light. If not, you can hold the trip meter button down and turn the key, but not start the vehicle. This will reset the light most of the time.
how to reset the vigo timing belt warning light
how to reset oil timing on 1990 toyota
coaster bus how do you reset timing belt light 2010
The easiest way to reset the timing belt indicator lamp in your Toyota automobile is to remove the fuse for the indicator lamp. Keep the fuse out for approximately 30 seconds. Put the fuse back in and the indicator light should be off.
on 2014 Toyota hiace
The timing belt warning light, on a Toyota Innova, can be reset by removing the timing belt warning light fuse. Leaves the fuse out for 10 seconds and put it back in.