Want this question answered?
check your transmission
100,000
Two Guys Garage - 2001 2013-03-02 was released on: USA: 2 March 2013
A Dodge Dakota does not have a reset switch.
there is no need to reset the computer for an 02 sensor.
You should have a red reset button that is located with your fuses. pull off your fuse box cover and you will see it.
start explorer press setup when it comes to engine check push RESET it says new oil push and hold reset it busses and it is reset until next oil change
With an OBD2 scan tool after the problem is repaired.
GM vehicles do not use inertia/reset switches.
on a 02 m8 it should have a chain and not a belt, the chain should be good for 100,000 miles
Take the car to your nearest VW garage n get the thing serviced - If a service is needed! Otherwise: Note: the Service Reminder Indicator displays 3 messages: OEL, IN 01, and IN 02. These display to alert the driver to follow the items listed under the manufacturer's service interval. To reset the message displays, turn the ignition switch on. Press and hold the odometer reset button "A" located below the speedometer. Turn off the ignition while holding the button. "OEL" will display on the indicator. Press and hold the lower digital clock reset button "B" until five dashes appear in the display. If needed, press the odometer reset button until "IN 01" appears and then press the clock reset button until five dashes appear. If needed, press the odometer reset button until "IN 02" is displayed and then press the clock reset button until five dashes appear. To exit reset mode, turn the ignition switch on and when "IN 01" appears, turn the ignition switch off.
General Motors products do not use inertia/reset switches.