0
GM vehicles do not use inertia/reset switches.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is fuel shut-off switch on an 02 gmc 1500 pu?
Gm vehicle do not have one.
Where is the fuel pump inertia switch in 02 mercury mountaineer?
According to the 2002 Mercury Mountaineer Owner Guide : The fuel pump shut off switch ( inertia switch ) is in the front passenger footwell , by the kick panel
02 Elantra wrecked head on collision repaired and immediately afterwards the main baring in the engine failed and now needs engine replaced Had no problems what so ever before the wreck Any thoughts?
During the accident the engine did not shut off in time and it damaged the barring. It happens but there is a shut off switch that is in the car to shut it off. It must have failed.
When was Shut It Down created?
Shut It Down was created on 202003-02-02.
Does a napa 21522 fit a chevey suburban?
it fits a 2000 suburban 2500. an 01/02 suburban 2500 v8 vortec... and a 00-02 suburban 1500. ur napa store can answer ur questions too
Passenger side brake lights wont shut off on your 02 Jaguar xj8 Vanden Plas?
The High side switch has shorted in the Security/Locking Module. Purchase a BTS428L2/TO252-5 switch from Digikey.com, about $4. Get a TV repair guy to solder a new one on for about $50.
When was Shut It Down - song - created?
Shut It Down - song - was created on 2009-11-02.
When was Shut Up I Am Dreaming created?
Shut Up I Am Dreaming was created on 2006-05-02.
When was Shut 'Em Down created?
Shut 'Em Down was created on 1998-06-02.
Does engine have turn off in engine if oil low in 02 Kia Sedona?
Some have a safety switch that shuts fuel pump off if oil pressure drops
Is 02 sensor bank 2 on the passenger side on 2003 chevy suburban?
YES
What is wrong when the rear lights of 02 Chrysler town and countrywon't shut off unless you pull the brake light fuse?
Brake Lights "Stuck" ONUsually this is caused by the brake light switch position NOT being adjusted properly.Another possibility is that the brake pedal is NOT returning fully to the retracted position.Another possibility is that the brake light switch internal contacts have become stuck together [welded from heat buildup.
