you need a scanner to program your new key to ur NATS IMMU. call me, i can help +639176222223 -Jerry
trying to set up and program 2003 Nissan altima key fob
You will get a Keyless Entry Remote Fob Clicker for your 2000 Nissan Maxima SE.
if you cannot pop it open then you either contact Nissan or throw it in the lake?
you need a new fob
The key fob battery on a 2008 Nissan Altima is replaced by using a coin to open the rear of the case. The battery can then be popped out and a new one installed.
The key is inside of the key fob. There is a small switch on the back of fob. Push it towards the outside and hold it. While holding the switch, pull on the key ring and your key will slide out.
Get a new key or get a hammer and smash the boot open.
I went to Timsons to have a new betery put inkey fob he could not do it as it would wipe memory of key and the car would not start where do I now take key for battery change
It may be necessary to have dealer equipment reintroduce the key fob to your vehicle. First, I would double check that the battery is installed correctly, and take a second look at your owners manual. I didn't see anything about reprogramming, but I may have missed something.One thing to try: Sit in the car, at the same time, hold down the power door lock button on the door and the power door lock button on the keyless entry. This works on some cars, and when it does, the horn will honk once after a few seconds to let you know reprogramming was successful.Good luck : )http://www.scribd.com/doc/10496778/Nissan-Xtrail-Owner-Manualhere is a link that may help
Foward Operating Base Loyalty - an operating base on the east side of Baghdad in 9-Nissan, South of Sadr City
I'm assuming yours has push button start. the mechanical key should always stay in the key fob. it will only unlock the door and glove box manually. if the battery should run down in the fob just stick the fob with key in it in the slot below and to the left of the steering wheel to start.
Free On Board (FOB)