WHY would you want to do that??
Do the older mirrors 'look' better?
But if you are trying to $ave $ then make sure that the mounting holes are the same as the original ones.
Make sure that you do NOT cut the wires from the control mechasnism and carefully route them so that they do not get damaged.
you might check for a blown fuse.
Always check the fuses first. Mirrors implies both. Fuse, switch, loose connection at switch.
Power seat relay location for 1996 Blazer
my Chevy blazer power seat on my 1996 Chevy blazer isn't working
If it has power mirrors, the switch is on the door.
The simplest (and, really, only feasible way) is to get a set of doors with PDLs and swap them in, then you should find a wiring diagram for a vehicle with PDLs and duplicate that.
The power of the engine of the Chevrolet blazer 8cyl 1968 is 435 hp
We need to know what year that S10 Blazer is.
The fuse for the power mirrors on a 96 Chevy Silverado K1500 are found under the hood.
It is now 2013, and yes power folding mirrors are available.It is now 2013, and yes power folding mirrors are available.
they arent mirrors, there solar pannels, which absorb the sunlight .
Telescoping mirrors could be better, but power heated flip down and up.
seat fuse location for 1996 blazer
No. the door panel and plug are diffrent
Mirrors Locks (MIR LKS). The fuse is for the power mirrors and power locks on the vehicle.
The Blazer Bravada Power Steering Fluid is the kind of power steering fluid used in a 2001 Chevy S-10 Blazer 4.3 V6. The Van Power Steering Fluid Power Steering Fluid is also a fluid that is used.
BRONCO power BABY a bronco will pull a blazer anyday. hook em
no power to either side mirrors
Power options: Power Windows, Power Locks, Cruise Control, Power Mirrors, Power Seats
Its vast and impressive architecture mirrors the power and longevity of the Roman Empire.
They were optional.
What I did was take the mirrors off the aftermarket mirror's, remove the motor and four wire connection. Take off the stock power mirrors, removed the mirrors, took out the stock motors and wire harness. Installed the stock motors and wire harness into the aftermarket mirrors. Plugged the wire harness back in, wired up the lights and turn indicators on the mirrors and they are working just fine.