Serpentine Belt
Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate the belt tensioner, and then put the belt back on as shown in the diagram.
If it is not you can run down to your nearest auto parts store and they can print it out for you or just buy the Hayes or chilton manual on your car. It only cost a few bucks and it well helps you out later down the line if something else brakes.
Relieve Serpentine Belt Tension.
Before removing the belt, note its routing around all applicable pulleys for ease of installation.
1. Using a box end wrench on the tensioner pulley center bolt, rotate the tensioner assembly clockwise.
2. While holding the tensioner in this position, remove the alternator drive belt from one or two of the applicable pulleys.
Use a box end wrench to rotate the tensioner pulley assembly clockwise to relieve serpentine belt tension
1. Slowly release the tensioner, and remove the box end wrench from the center bolt.
2. Remove the alternator drive belt from the remaining applicable pulleys.
To install:
When installing the drive belt on the pulleys, ensure that it is properly seated in all of the pulley grooves.
1. Using the box end wrench, rotate the tensioner clockwise again, then position the drive belt on all of the pulleys.
2. Slowly release the tensioner until it eliminates all drive belt slack.
3. Inspect the tensioner indicator to be sure that the belt is properly tensioned. If the belt tension is incorrect, the belt should be replaced with a new one, or, if installing a new belt, the belt may not be the correct belt for your vehicle.
4. Then start the engine. Ensure that the drive belt works properly.
how do you chance a serpentine belt on a 1996 ford escort
I need daigram of 2001 ford focus se serpentine belt
Is there not a drawing on one of the information stickers at the front of the engine compartment that shows how the serpentine belt " runs " My 1995 Ford EXPLORER has an information sticker for that
I need the routing for the serpentine belt for 1990 Ford 150?
Away from the serpentine belt
were do i find a diagram for the serpentine belt for a 01 ford expedition
hat is the serpentine belt routing for 1990 ford 150 4.9
Yes. This car has a Serpentine belt. Part Number-#DY5060955
This should help just fine http://www.rldassociates.com/zx2/howto/belt.htm
Can someone tell me how to install the serpentine belt on a 2006 ford fusion? I need an answer ASAP. Thanks
I need a diagram of 2003 ford crown victoria serpentine belt.
replacing serpentine ford f650