Use a sieve to allow the sand to pass through, leaving the iron nails behind. Or use a magnet to attract the nails and remove them from the sand.
Because - you can simply evaporate the water by heating it, and collect the water in a separate vessel - leaving the dry sand intact.
what is used to measure dry sand
You just need to use filter paper. use the filter paper than just pour the water and sand on the filter paper. the sand will go to the filter paper while the water will go straight to the beaker or anything below it. That is how you separate it. To separate sand and water you could pour the mixture through a filter. The water would pass through the filter but the sand would remain on top of the filter. If you didn't need to save the water you could evaporate the water and leave the dry sand behind. Or allow the sand to settle and carefully pour off the water first. Then allow the remaining water to evaporate.
You canseparate them with a liquid known a sulfuric acid. (it penetrates thought almost anything) Those things that are not soluble can be removed by filters, the sawdust, sand, rocks and iron. The salt and soluble iron will need to be removed chemically. You can evaporate the water and you'll have the salt after removing any iron chemically. +++ The question didn't say anything about destroying any of the materials! Sulphuric Acid is highly corrosive and would attack the iron and sawdust at least. And your skin if you splash it on yourself. I'm not sure about the salt but it would not harm the sand (quartz, or silicon dioxide grains). You can extract the rocks by sieving the mixture; and the iron (filings I presume) with a magnet. That's a start. Now you can flood the mixture with water and let the sawdust float. Scoop it from the surface of the water, and dry it. That leaves sand and salt. Dissolve the salt, filter the brine to remove the sand; dry the sand and evaporate the brine to leave the salt. BTW I hope Dale and I were not helping someone cheat with what look suspiciously like a homework question....
Sand
Rusting of iron needs the presence of water.
Use a magent to pick out the iron particles. Soak the remainder in water until the salt is dissolved - dry the water, leaving behind a pile of salt. Mix the rest with mercury - the gold clings to the mercury, leaving behind a pile of sand. Use cyanide to separate the gold out of the mercury and remove the mercury.
Do Not Kow
Use a magnet to remove the iron filings. Filter the remainder to separate the insoluble chalk powder from the water. Wash and dry the iron filings as they will be contaminated. Dry the chalk powder to remove traces of water.
Lawn sand is a mixture of fine dry sand and sulphate of iron which is used to kill moss in lawns and encourage growth.
The sand in Australia is red because of the large amount of iron oxide found in that sand. Australia is known for its dry climate and red sands.
According to Holt Science & Technolgy (Phisical science text book)pass a magnet over the mixture and the iron filings will be attracted to it.
Because - you can simply evaporate the water by heating it, and collect the water in a separate vessel - leaving the dry sand intact.
what is used to measure dry sand
Dry sand is dry because it has little or no water in it. Wet sand is wet because it is saturated with water. Wet sand is often found on ocean beaches.
dry sand
yes,moon sand is always dry