It depends on what kind of engine you have. A single overhead cam involves lining up the TDC mark on the crankshaft with the TDC mark on the timing belt cover, then making sure the #1 mark and the arrow on the cam gear lines up with the TDC mark on the cylinder head at the same time. This will involve removing the timing belt from at least the cam gear. Once all this lines up, you will need a timing gun to precision adjust the timing by moving the distributor (assuming your vehicle has a distributor, if not its probably computer controlled) either left or right until timing is exactly where you want it. Manufacturer specs for timing are usually under the hood of the car. If you have a dual overhead cam, the process is similar, but involves lining up more marks/ gears etc.. If all else fails, go to your nearest auto parts store and buy a Chilton or Haynes manual for the car, and it will describe in detail what you will need to do. These cost around $20 and are one of the best investments you can make if you plan on keeping the vehicle. Hope this helps. -Shaun
what timing are you trying to set? the cam timing or the ignition timing?
That requires an engine scanner to set the timing.
Ignition timing is automatically set. sorry.
Ignition timing or valve timing?
Ignition timing has no adjustment on these bikes.
Hoo I set the correct timing on a 1993 mazda protege
You can not set the igitniton timing yourself.You can check it but not set it.The timing is ran off a crankshaft sensor.Idle timing is 27 degrees
its set by the ecu
The ignition timing is probably controlled by the computer, and cannot be manually set. Check to see if it has a distributor, if it does it may be adjustable, if not, it is not adjustable.
To set the ignition timing on a Ford Probe GT 95 with an MX engine, remove the two 12 mm head bolts holding the distributor in place. Then rotate the distributor to set the ignition timing.
It requires an ENGINE SCANNER to set the ignition timing on that year of engine.
Adjusting the distributor sets the ignition timing. To set timing you need to align the timing marks as specified by the manufacture using a timing light.