answersLogoWhite

0

That requires an engine scanner to set the timing.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What is ignition timing for 1998 Chevy silverado 305?

The timing on that year engine is computer controlled. It requires an engine scanner to set the timing. YOU CAN NOT USE A TIMING LIGHT.


How do SET timing on a 1998 ford contour se?

Ignition timing is automatically set. sorry.


1985 Chevy how do you set the ignition timing without using the timing marks?

You dont.


How do set the timing on a 2001 Chevy 5.3?

It requires an ENGINE SCANNER to set the ignition timing on that year of engine.


What is the Ignition Timing setting for a 1974 Chevy 454?

The base ignition timing for a 1974 Chevy 454 engine is between 8 and 12 degrees below top dead center. A timing light is needed to accurate set ignition timing.


How do you set the timing for a 1998 Chevy Malibu 3.1 liter?

timing was set at factory,there is no adjustment. it is controlled by ecm!!


How do you set timing on 2001 Chevy s- 10 2.0l?

Chevy S10 in 2001 didn't have a 2.0L engine. They had a 2.2L engine and it has a (DIS) distributorless ignition system. There is no timing to set.


How do you set the timing on an 1988 Chevy Celebrity?

The 1988 Chevy Celebrity uses distributorless ignition. There is no provision to alter timing, the engine control module takes care of that.


Is possble to adust the ignition time on 1998 Chevy K1500?

YES but you MUST use an OBD2 engine scanner to do it. But if there is NO CHECK ENGINE LIGHT ON then there is NO need to set the timing. It is computer controlled.


Setting timing on 1998 Chevy truck?

That requires an OBD2 engine scanner to set the timing. You can NO longer use a timing light.


What should the timing be set at for a 1998 Chevy pickup with a 5.7 motor?

There is no timing ajustment, Its controled by ECM- Computer.


How do you set ignition timing 1995 Chevy Lumina van?

If you have the 3.8L engine, ignition timing is controlled by the computer and cannot be altered without making changes to the computer. If you have the 3.1L engine, which has a distributor, you can set the timing as you would on any engine with a distributor.

Trending Questions
1966 mustang alternaltor smokes when battery is connected only smokes from wire coming from starter solenoid? How do you find a freon leak on a 2000 Chevy Metro? How do you change a fuel filter on a Chevrolet trailblazer? How many lugs on 2004 expedition? What is the gross vehicle weight of the 2008 GMC Yukon-XL? Where is the computer located in a 1995 Mercury Tracer? How do you replace ignition switch on 04 avalanche? How much does it cost for a insurance for a 2010 dodge challenger? What can solve a Buick Reatta engine overheating problem after replacing water pump flushing rad. System and new themostat and cooling fans are working correctly? How do you turn off seatbelt alarm? Why does the blower motor in a 97 Cadillac DeVille work sometimes and sometimes not work even after it has been replaced? If I Changed fuel pump and now the relay is making clicking sound and wont start on 1990 cougar what is wrong? How much does a 2005 Ford F-250 4x4 crew cab gas weigh? How do you change the water pump on a 2000 Chevy S10 truck? Can I put a ls1 engine in a 1979 Trans Am? What is needed for a tune up on a 2002 ford expedition? What is it to shift from one form to another? What would a 1999 2.4 L Breeze coolant reservoir get hot after long stop and go drive I changed the thermostat in the fall because of this. No change since. Highway driving is ok? What could the problem be when your car idles too slow and dies when you let off of the gas pedal? Is 700MM bicycle tire fits 27 inch bicycle rim?