answersLogoWhite

0

The base ignition timing for a 1974 Chevy 454 engine is between 8 and 12 degrees below top dead center. A timing light is needed to accurate set ignition timing.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What RPM timing be set at on 350 Chevy 1974 engine?

Rpm needs to be set at 800 - 900 .. that is factory setting.


Wiring diagram for ignition switch for 1974 Chevy truck?

Ignition wiring diagram


How do i fix a 1974 Chevy Nova ignition?

whats wrong with it?


What is the ignition timing setting for a 1974 Chevrolet 350 engine?

The ignition timing setting for a 1974 Chevrolet 350 engine is typically around 4 to 6 degrees before top dead center (BTDC) at idle, depending on specific configurations and modifications. It's important to consult the vehicle's service manual or specifications for the exact timing based on the engine's setup and any aftermarket components. Additionally, timing may vary based on fuel type and other factors, so adjustments should be made accordingly for optimal performance.


What is the timing setting for a 1974 350 Chevy motor id ending with tmx cab and chasis motor dump truck school bus I have a couple books and the timing goes grom 4 to 8 and idle goes from 700 to 900?

Yes, the timing changes with RPM with internal regulator, set the timing so that the performance will be pleasant and the motor will still not knock during idle. With higher octane fuel you can set the ignition to begin sooner, with low-octane fuel (such as was used in 1974) you would have to stick with that factory settings, note that most of the world does not offer option to tank such poor fuels as were available in 1974.


How do you change a timing belt and set ignition timing on a 1974 2.0 ford engine with after market pulleys that have no timing marks?

remove the timing cover and mark the belt and pulleys with liquid paper then transfer the marks onto the new belt piece of cake good luck


What should timing be on a 1974 Chevy c10 2wd pickup with a 350 cu inch engine?

4 degrees Before Top Dead Center


What degree is timing set on 1974 Gran Torino?

The timing for a 1974 Ford Gran Torino typically ranges from 6 to 10 degrees BTDC (before top dead center) for the initial ignition timing. However, the exact specification can vary depending on the engine type and emissions control equipment. It's always a good idea to consult the vehicle's service manual for the specific engine configuration to ensure proper timing settings.


What is the timing setting for a 72 dodge charger?

Start the engine and point the timing light at the timing marks. The flashing timing light will cause the timing mark on the harmonic balancer appear to be stationary and aligned with the timing marker. It should be lined up with "10 BEFORE." If not, turn the distributor until it is. Turn off the engine and tighten down the distributor hold-down. Unhook the timing light. Read more: How to Set the Timing on a 1974 Dodge 318 Motor | eHow.com http://www.ehow.com/how_7405118_set-1974-dodge-318-motor.html#ixzz2S9e9ResE


How do you remove a heater core to a 1974 Chevy impala?

How do i remove a heater core to a 1974 chevy impala?


What size timing chain cover gasket do you need for a 1974 Chevy 350?

The gasket is the same for all of them, but you'd want to use the thick seal where it mates to the oil pan.


What is the point setting for a 1988 Chevy 305 engine?

Set the points for 30 degrees dwell. 1988 305 has electronic ignition.NO POINTS.last year for points was 1974