answersLogoWhite

0


Best Answer

remove the timing cover and mark the belt and pulleys with liquid paper then transfer the marks onto the new belt piece of cake good luck

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change a timing belt and set ignition timing on a 1974 2.0 ford engine with after market pulleys that have no timing marks?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is The igniton Timing for a Toyota 1uzfe?

the best ignition timing i have achieved using a dyno is 8 deg btdc at 700 rpm, using after market engine management


Why does prices of shares change in the share market?

why does prices of shares change in the shares of market?


What else besides migration might account for a change in market size?

A reason for market change can be tax laws. Tax laws in a country can change the market profoundly.


What would cause radio in 2005 ford focus to come on with key out of ignition?

Is it an "after-market" radio? It sounds like it was wired to a "hot" terminal that is not controlled by the ignition switch.


How do you pull a wire from ignition switch to connect a off market stereo for a 2002 Chevy cavalier it does not have the ignition switch wire?

i do not know go to a car stereo install ... store


What could be wrong if an E-320 will not start after the key is in the ignition?

It could be as simple as replacing the ignition key. Each key has a chip that comunicates directly with the car. If the chip goes bad, the car's starter will turn over, but the engine will not start. There is no after market key that will work. You must purchase them from a dealer. Costly little buggers, roughly around $150....... what kind of vehicle is this?


What will change in market price cause movement along?

Change in market price will cause movement along the demand curve.


What is the best engine mount brand in the market?

oem


What are wing pulleys?

Wing pulley is a type of conveyor tail pulley that has a flat bar welded to a gusset (like a T cross-section) then welded to a cylindrical drum. There's usually a crown on the T that goes the width of the pulley to maintain belt tracking, but flat wing pulleys are also available in the market.


Describe the forces that move a market toward its equilibrium?

The actions of the buyers and sellers move a market towards its equilibrium.


What is the ignition-point of nylon?

I'have found this data atTECHNOLOGY SUPPLIES LTDPhoenix House Tern Hill Market Drayton Shropshire TF9 3PXTel: 01630 637300 Fax: 01630 637302Flash Ignition Temp: 450º C.Self Ignition Temp: 465º C.


What changes the equilibrium quantity to change?

It changes when the market demand and or market supply changes.