answersLogoWhite
notificationBell
Chevy Impala
1995-2005 Chevy Cavaliers

How do you set the cloak on a 2003 Chevy Impala?


Top Answer
User Avatar
Wiki User
Answered 2010-11-16 02:47:42

Get a Dagger, then go to page 3-52 of your "Owner's Manual, under Instrument Panel - Audio System(s) - Setting the Time...

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


how do you set the clock on a 2003 chevrolet trailblazer


A 1967 Chevy Impala with a 283 motor should run at a temperature between 180 and 195 degrees. The temperature is set by the thermostat which controls coolant flow.


if it is a 3800 series 2 or 3 engine, look at back of engine near passenger side firewall...it is set down low just rear of the belt


The little hour and minute buttons are under the larger display button at the bottom left corner of your stereo. Press and hold one of these buttons and your time will change.


timing is set by pcm, at factory!!


the Chevy 5300, 2003 and other v8 built in that year the spark plug gap should be set at .060


you can't. There is no adjustment it is computer controlled.


My 2003 impala has a button for the hour and minute on either side of the tune/display knob, just push the hour (HR) button for a second or 2 and it will start changing the hour, then adjust the minutes with the minute (MN) button.


Hook up a dwell meter and turn the 1/8" hex screw on the point set to achieve 30 degrees dwell. (Engine running)


327 is a Chevy motor. Mostly put in a older Impala or older Malibu, But you can do swap and put it in anything that has the same set up.


See Setting the Time on page 3-60 of your "Owner's Manual", under Section 3: Instrument Panel - Audio System.....


On the left side there should be a stick for your windshield wipers and a nob on the dash semi-close to the button for the trunk. You turn that nob to set the lights inside and outside the car. The windshield wiper stick if you pull it down, or towards the dash- it should put your brights on.



When it go's out and the engine quits are when you can no longer set the timing with an engine scanner.


There are no points on a 96.


Yes you can and you can either just buy aluminum end plugs or buy a new compressor manifold hose set for a 2003 Chevy Tahoe without rear a/c.........


How do you set the timing on a 2000 Chevy blazer (V6)


Yes But just because there is room does not make it easy. You will need a transmision, special modified drve shaft and a complete donor set up of accessories from the car the 427 came from.


Your owners manual has all the info you need on that.


get out your owners manual and it will tell you how to do it.


you can do 2 things for this 1 you can turn the key off and on 3 times or 2- you have to go into radio and to re set the oil life to do that turn the car on,,,do not start it.. then turn the radio off press the on buton of the radio and hold it until you see the radio setting appear ..then use the arrow to move the option to get to the oil life symbol..then re set it there..\ hop this helped/


Turnable. They should be steel. If you are getting chatter, you might have a rotor that got too hot, or a bad set of bits on your lathe. But you can always tell the difference just in weight if you are ever questionable.




On the Set - 2003 is rated/received certificates of: Australia:PG