There are two rubber buttons next to the clock/radio display. Just push those in with a pen or needle until you have the time where you want it. On the right front of the radio display, there are two buttons, the one at the top marked with an "H" for hours and one beneath it marked with an "M" for minutes. The picture below may or may not be like your radio, but will be similar. http://images.Google.com/imgres?imgurl=http://upload.wikimedia.org/wikipedia/commons/d/d4/Chrysler_Radio_RBK.JPG&imgrefurl=http://commons.wikimedia.org/wiki/Image:Chrysler_Radio_RBK.JPG&h=480&w=640&sz=158&hl=en&start=3&um=1&usg=__Yj3hpIXWg52DCotG6iAZk8nE_YQ=&tbnid=c46OVvgNS01PmM:&tbnh=103&tbnw=137&prev=/images%3Fq%3Dchrysler%2Bradios%26um%3D1%26hl%3Den%26sa%3DN
Read your owner's manual. This information can be found there.
how do you set the clock on a 2001 oldismobile aurora
on the right side of the clock you will notice two tiny inverted pin dots, use an ink pen or something the top one is the hours and the botom one is the minutes.
belt giagram for a 98 dodge stratus 2.4
'how do I set the clock on a 2001 mercury mountaineer'
How do I set the time?
Loosen the set screw.
The timing marks on a '97 Dodge Stratus are located on the timing chain and the camshaft sprocket. They must be aligned to set the initial timing.
Use the set buttons.
My 2000 Dodge Durango , my clock does not have the h or the m for setting the clock! any suggestions on how to set the clock????? Turn radio on, press set, press sel, now seek should change time.
You can set the clock, on your 2005 Dodge ram, by holding in the volume button. Turning the tuning knob as the volume button is held in. The time will advance with the tuning knob.
To replace the ignition wire set on a 1998 Dodge Stratus ES 2.5L, you must first disconnect the wires under the instrument panel. You would then hook it up in the exact same order.
by changing the time
look in your owners manual.
The clock on the radio can be set by two buttons found to the right on the display screen. H for hour and M for minute.
Twist the thing on the dash.
To the right of the clock there are two small buttons labeled HR & MIN. Simply push and hold them in (one at a time) with a pen or equivilent pointy object to set clock
The transmission computer has detected a malfunction and set a trouble code.
Press and hold down clock button while pressing hr/min.
You shouldn't have to - unless your on-board computer has gone bad, but then your engine shouldn't even fire.
Push the set button and within 10 seconds press the seek and scan buttons.
hold boton that says clock then use the preset #4 and 6 for time ajusting
I need to set the timing belt in my car for a Dodge Stratus 1998, that has a 2.5 motor V6.I do have the timing belt already on the car, but it not on the right setting. Please someone help me with this question about setting the timing belt.
Press the set buttons for hour and minute.