The radio/CD player must NOT be turned on. Press the DISP button on the right-hand side until the the clock display starts flashing. Then press the Up or Down arrows to the left of the clock display to move the time forward or backward. These are the buttons you would use to change tracks or stations when the CD/radio is on. When done, press the DISP button again to stop the time from flashing.
how to time a 1999 Hyundai elantr glsAnswerhow to set timing belt on Hyundai elantra gls figure
The spark plug gap for a 2000 Hyundai Elantra should be set at .044 inches. New spark plugs will be preset at the factory.
You need to switch off the stereo and then you can use the buttons next to the clock to change the time. this also changes the time on the stereo.
Owner's manual.
Turn your car on, so that the radio can be turned on and off. Then turn your radio off. After is it off, push the clock button and while holding clock, use seek to change the hour and tune to change the minutes.
The clock on a 2004 Civic can be set using the preset buttons. Hold down the scan button on the radio and it will allow the clock to be adjusted.
This is what I did:Turn the key to the accessory position. Turn on the radio. Hit the Disp button on the right. When the clock comes up, hit Disp again to make it flash. Use the radio scan back button for hour and use scan forward for mins. Once set hit disp again to start the clock.Hope this helps : )
reverse backwards for 200 yards then use the buttons on the side of the clock
there are two little buttons recessed in to the right of the clock. Use a pen or something similar to push the buttons in. top is for the hour and bottom is for minutes
how to set time on Renault megaine 59 plate no buttons
how to set cloc radio dst
My ELANTRA'S camadjuster brake. what is the correct way to set the valvetiming?