using a variable resistor we can adjust the sensitivity of a light dependent resistor
The disadvantages of automatic street lights using LDR, light dependent resistor, is the noticeable on/off time difference between sunny and cloudy or rainy days. If the timer is set for a specific time, This concept uses the transistor to operate the on/off switch. If the timer is set for a specific time, the brightness of the light will vary with the amount of light that has fallen.
No, you cannot adjust the sensitivity level.
There is the light-dependent stage, where sunlight interacts with choloropyll to set up an electron-transport chain, then there is the chemical stage, where glucose molecules are synthesized from CO2 and H2O.
A potentiometer.
To set up a motion sensor light, first choose a suitable location for the light. Then, follow the manufacturer's instructions to mount the light securely. Connect the wires according to the wiring diagram provided. Adjust the settings, such as sensitivity and duration, as needed. Test the light to ensure it is working properly.
depends on the sensitivity mine goes off every time a snow flake passes it because of its high sensitivity if yours has a high sensitivity it is possible but very unlikely, if it has a low sensitivity i highly doubt a bug will set it off
A thermister is a device that changes resistance depending on temperature. A photo resistor changes resistance based on light. Both of these could be used with an amplifying circuit to vary current flow.
the features of the kodak c315 are that it is 12 mega pixels; has 10.2 zoom; can be set to 20 different light or weather sensitivity settings to take a pic.
Yes it is. The filament in a standard incandescent bulb is a type of resistor. An incandescent light bulb contains tungsten which reduces electricity and converts electricity to heat and light. All incandescent bulbs are resistors, but only a fraction of resistors are bulbs. If you want to see if a bulb is a resistor, try adding another bulb in series without changing the voltage. Both bulbs will be very dim. Another way to test this is to get a multimeter and set the meter to the resistance setting. If you get any value other than zero, then it is functioning as a resistor.
A preset resistor is used in some circuits to change the resistance. The preset resistor enables the circuit to be more or less sensitive thereby altering the resistance.
u cant
No. They are dependent on each other. One set of lights is red when the other is green, and vice versa. That makes them dependent events.If you are talking about a different usage besides traffic light modeling, then please restate the question giving more details.