top right corner has a H for hours and a M for minutes. Look for the tiny dimples and set the time using a pen or tooth pick. Push in on the dimple and the number will change right before your very eyes! :-)
Which Forester, and which time? Are you talking about a clock or engine timing? Is the clock stand-alone or on a radio? Is it the factory radio? --Ken
whats a radio
push and hold
*Turn off the radio press the 'set time' button while pressing the radio station buttons to set the time..
On some Chrysler radios there are two round holes on the display panel of the radio with a letter h and m for hours and minutes. just take pen point and push into these holes to set the time.
Answermost clocks you turn off the radio and use the set buttons Turn radio off with ignition on or running.press set button and use arrow back button for hours and arrow forward button for minutes on oem factory cassette am/fm radio ....hope this helps ..worked for me
you get a pen or something and push the little button on the left had side and press time till it goes up to the right time, the owners manule shows it!
Radio controlled watches use radio waves that are set by synchronizing a time code that are transmitted by a radio transmitter. These radio controlled watches are used to set and display the time accurately.
Radio codes are set at the factory and cannot be reset. If you lost the code go to your dealer and have them look it up.
It displays on the factory radio. There is a button on the OEM radio to either show the time or radio station.
With the key turned on, and the radio turned off, you press the SET button, then use your seek and scan buttons to set the time.
On the factory radio you tune to the channel you want and press and hold the number you want it programmed on (1-6)