0
To set the valve preload on a 1988 Ford Ranger, first ensure the engine is at top dead center (TDC) on the compression stroke for the cylinder you're adjusting. Then, loosen the rocker arm adjustment nut and turn the pushrod until there's a slight resistance, indicating the lifter is engaged. Tighten the adjustment nut to the specified torque, usually around 20-25 ft-lbs, while checking for any additional play and ensuring the pushrod can still rotate freely. Repeat this process for each cylinder as needed.
What else can I help you with?
What is the load capacity for a 2008 Ford Ranger?
The load capacity for a 2008 Ford Ranger varies depending on the specific model and configuration. Generally, it has a payload capacity ranging from about 1,200 to 1,400 pounds. It's important to check the vehicle's owner manual or the door jamb sticker for the exact capacity for your specific Ranger variant.
How much can a 1996 ford ranger haul?
I have a 95 ranger and I hauled a load of pine logs about 25 miles weighing in at 3 1/2 tons
Where is the load sensor valve on a ford escort van located?
IN FRONT OF THE OFFSIDE REAR DAMPER
Ford Ranger Code 0300 and 0301 problem?
Code P0300 is Random misfire detected; Code P0301 is Misfire at cylinder 1 detected. Haynes Manual #36071, 1993-2005 Ford Ranger Pick-ups Need a head job, your friend must have over heated the engine, valve is vent, can only notice when is hot, or under load the engine, will missed fire, intake valve damage on cyl #1, best to get a whole head job
2.9 Ford Ranger has no power when under load?
A 2.9 Ford Ranger NEVER has much power, but if it's lower than normal, try running a computer diag scan to see if the computer has picked up something.
How do you replace shocks on 2000 ford ranger?
The shocks on a 2000 Ford Ranger are replaced by jacking the vehicle up, removing the wheels, unbolting the shock, and removing it from the vehicle. Because the vehicle is supported off the ground, the shocks are not under load and can readily be replaced.
What is the load capacity of a 2001 Ford Ranger super cab?
i have a 2000 ford ranger xlt super cab 4x4. the bumper specs are 200lbs down force on hitch and 2000 lbs owners manual says 7000 lbs max total weight with things loaded.
1997 ford ranger 4 cylinder has a slight skip on load?
Sounds electical. If it has over 100K miles, have the plugs been changed? After this, it might get expensive.
What is the proper tire pressure for your 2004 ford ranger?
The proper pressure depends on the tire itself. The recommended tire pressure is stamped on the sidewall of the tire beside the load rating..
What is the load capacity for a 94 Ford Ranger?
The payloads for Ford Rangers 1993-1997 are as follows: Extended Cab 1550 lbs. Regular Cab / Long Bed 1650 lbs. Regular Cab / Short Bed 1650 lbs.
How do you check coil pack on 1998 ford ranger?
A coil pack can be checked for continuity and resistance with an ohm meter. But for heat or load failure the only way to check a coil pack is to replace it.
Can you plow snow with a 1994 ford ranger 2 wd?
u can plow with anything, but a ranger is a light truck. this means it will not have the traction to dig into the snow(4wd is the way to go ) . also the trans. is not built for the added load of plowing. I have a 1997 ranger xlt 4 wheel drive that I've used for 4 years to plow and it works fine.
