Want this question answered?
Rule of thumb: Open needle valve 1-1/2 turns and start the engine, let it warm up then slowly rotate needle valve clockwise until engine wants to stall then rotate needle valve counterclockwise until engine wants to stall. Set the valve in between the two extremes and fine tune from there for best setting.
They are set at .004 . Set with the timing mark is at 0 degrees and that cylinders valves are closed. Rotate 360 and set other side.
The valve lash on your 3306 Caterpillar diesel engine, can be set by adjusting the adjustment screw. The adjustment screw should not be set to tight.
5
5
To set the timing on a Toyota 22R engine find the distributor. The engine will have marks at which the distributor can be set. The OEM setting for a 22R engine is 5 degrees.
fire each valve set the 1 next 2 it
You're setting valve lash here. It shouldn't make any difference what mark it's on. You want the valve to close completely when the rocker comes up. With no more movement after that. Once you get one valve set, roll the engine over half way and set the other one. Set valve lash on both valves with piston at top dead center, the T mark lined up with the mark. Valves should be set at .02 for that model. You do not have to roll the engine through to set the valves. but it is a good idea to roll it through 360 degrees after setting is complete and recheck the settings
Mazda 323 familia valve timing set up
There is no setting....they are torqued to 20 foot pounds.
One can set an injector for a 320 diesel marine engine by setting the timing and duration.
The plug gap is 35 and the dwell setting is between 28-32, I like to set them at 30.