0
How do you shut off the high beams on 94 a buick lesabre custom?
Wiki User
∙ 14y ago
pull the blinker lever towards you. and they will click off
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why does motor for 1993 buick lesabre have very high idle weather driving or in park?
Type your answer here..
1993 buick lesabre wipers only work at low speed why?
The resitor is probably burnt out on the high mode
How do you cut the high beams on in a 2000 Buick Century?
On your switch lanes signal stick, on the left side of the wheel,you pull it towards you and the beams will come on. Pull them again and they will shut off.
94 buick lesabre where is the high speed blower relay?
Check AGAINST THE FIREWALL ON THE PASSENGERS SIDE BEHIND THE PLASTIC COVER
2003 buick lesabre error code p0108?
Trouble code P0108 means: MAP Sensor Circuit High Input
Is 800 to repair the front transmission seal on s '91 Buick LeSabre Custom 3.8 liter which is just starting to leak an unreasonable price?
For Calif and New York I would think it is about righht but is high for other parts of the country. Call some local garages for estimates.
How do you remove the headlamps on a 1997 Buick Lesabre?
I have a 1998 Buick LeSabre and to remove the headlights there are two screws on the front just to the inside of the high beam. Once you take these two screws out the headlight should slide towards the outside of the car and you can unplug the wire connector and you now have ht headlights off.
98 Buick Century both low beams go out while driving hi beams work?
Check the multifunction switch in the column first as it controls both high & low beams, as well as check the daytime running light module if so equipped.
Where is dimmer switch on 92 buick regal?
Pull the turn signal stalk towards you to activate your high/low beams
Why wont the headlights come on in a 94 Buick Skylark 6 cylinder custom if the parking lights and signals work and the brights work?
That car uses a single type 9004 bulb on each side of the car. The 9004 contains two filaments, one for low beam and one for high beam. If the high beams work but the low beams do not, then either the low beam filaments in both bulbs have burned out or there is a fault in the low beam feed circuit.
What might be wrong with the blower in a 1995 Buick LeSabre if you've replaced it the condenser and compressor are fine and fuses are OK?
Does the blower run? Runs only on high?
Why will my high beams work but my low beams do not on my 1994 Chevy half ton?
Your high beams work but your low beams do not because the switch is broken that switches between high and low beams. Electrical switches wear out.
