You don't. The idle speed is determined by the on board computer and the idle speed control (ISC).
warm up speed of turbine,andthe minimum speed of turbine before loading is called idle speed.
The idle speed is computer controlled. If the idle is too low, there is a problem with a ssensor or the idle speed motor.
idle speed controll or tps throttle sensor
The fast idle-speed on a 1994 Nissan D21 pickup is adjusted by turning the screw on the side of the throttle body. It increases the speed of the engine when the vehicle is idle before completely warming up.
The fast idle-speed on a 1994 Nissan D21 pickup is adjusted by turning the screw on the side of the throttle body. It increases the speed of the engine when the vehicle is idle before completely warming up.
idle speed motor on the throttle body.
You will want an idle speed between 750 and 900 rpm with the ac on and in gear (if auto).You will want an idle speed between 750 and 900 rpm with the ac on and in gear (if auto).
If you mean hunting at idle, the problem is caused by the idle speed being set too high or the idle switch is not properly adjusted. When the throttle is closed as indicated by the idle switch the fuel is cut off by the fuel cut solenoid until the engine speed drops below a preset speed. If the engine speed is higher than that speed and the idle switch is closed there is no fuel for the engine, thus the engine speed drops. When it drops below the preset speed the fuel is turned on and the engine speed goes back up.
As you are sitting on the bike, there is an idle adjustment screw on the left hand side of the carb about 1/3 of the way up on the slide. Turning the screw counterclockwise will slow the idle speed down on your bike and turning it clockwise will increase your idle speed ...Good luck
There is a idle screw on the throttle linkage on the carb that you can turn to increase the idle speed and then hook up your timing light to check the timing.
how to turn the idle down. See if it's carburetor or efi. There is a speed adjustment for either using the idle speed screw (carb) or air bypass adjustment screw. If either has no effect, see below-