Turn main water supply off in your basement. Adjust or replace shower shut off knob.
You replace the washer in the diverter so it won't let water out the faucet end when closed.
Remove the shower head and clean out anything that might be blocking it, such as hair or debris. Replace the shower head and turn on the water; the water should be running.
Remove the shower head and clean out anything that might be blocking it, such as hair or debris. Replace the shower head and turn on the water; the water should be running.
Turn on the shower faucet.
I have this problem with my shower head, what I do to fix it is turn on the sink in my bathroom to hot, this usually shuts it up
He is in the house in the shower stall. To get him out, turn the faucet.
To remove old shower pipes to install a new shower faucet, turn the main water off first. Then either cut the pipes at the joints or unscrew the washers holding the pipes together.
There was air in the line. When you turn off the water with the faucet running make sure you turn it back on with the faucet open. That will release any air caught in the lines. That faucet shut with one on a lower floor on and restoring water does not work. Fast and easy. 1. turn on affected faucet 2. shut off water 3. turn water back on 4. faucet should be running smoothly now
You need to do a leak test on the tub and shower. To ch'k the drain fill tub about 1/2 full without running the tub faucet next plug shower head and tub spout turn water on this will ch'k faucet Next run water on shower doors this is where the majority of leaks are found water running out and down the corner of the unit If tiled also ch'k tile grout.
Turn the water off to the faucet. Remove the handle. The top of the faucet should unscrew to get to the ball valve. Replace the valve and gaskets then reassemble the faucet.
you did not pay bill
Click on one or both of the faucet controls to turn on the shower. (red or blue tap)
Yes, normally H signifies hot water, and C signifies cold water.